Clearance LinesCompany ProfileWebShop

Arduino Ethernet Shield Rev3 with PoE Module

Arduino Ethernet Shield Rev3 with PoE Module

Specifications:

  
  
  
  
  
  
  
  
  
  
  
  
  
  
  
  

Dimensions

68.6 x 53.3mm

Weight

g

Download Manual >Download the Handbook for full specifications and applications
The Arduino Ethernet Shield with PoE (power-over-Ethernet) Module allows an Arduino board to connect to the internet. It is based on the Wiznet W5100 ethernet chip (datasheet). The Wiznet W5100 provides a network (IP) stack capable of both TCP and UDP. It supports up to four simultaneous socket connections. Use the Ethernet library to write sketches which connect to the internet using the shield. The ethernet shield connects to an Arduino board using long wire-wrap headers which extend through the shield. This keeps the pin layout intact and allows another shield to be stacked on top.

The R3 version brings to this shield the 1.0 standard pinout that consist in 4 additional pins: 2 of them placed near the AREF pin, that are used for TWI communication, and the other 2 are placed near the RESET pin. The IOREF pin is used to adapt the shield to the board on which is mounted. The last one is not connected and is reserved for future uses.

The latest revision of the shield adds a micro-SD card slot, which can be used to store files for serving over the network. It is compatible with the Arduino Duemilanove and Mega (using the Ethernet library). It also have a separate power-over-Ethernet (PoE) module that is soldered to the board to provide power from a conventional twisted pair Category 5 Ethernet cable. It is IEEE802.3af compliant, and works with all compliant PoE injectors currently available

Arduino Ethernet Shield Rev3 with PoE Module
Order Code Each 
A000075Arduino Ethernet Shield Rev3 with PoE Module40.02 

 

 

sales@esr.co.uk

Tel: 0191 251 4363

Fax: 0191 252 2296

 
 

Place your Order  here Orders accepted subject to our Terms and Conditions

All Prices are in Pounds Sterling and Exclude VAT